编辑文件 - module-setup.sh

✏️ 正在编辑: module-setup.sh

路径: /usr/lib/dracut/modules.d/01systemd-repart/module-setup.sh
提示: 您可以编辑任何文件（包括二进制文件），但请注意不当修改可能导致文件损坏。

#!/usr/bin/bash
# This file is part of dracut.
# SPDX-License-Identifier: GPL-2.0-or-later

# Prerequisite check(s) for module.
check() {

# If the binary(s) requirements are not fulfilled the module can't be installed.
    require_binaries systemd-repart || return 1

# Return 255 to only include the module, if another module requires it.
    return 255

}

# Module dependency requirements.
depends() {

# Return 0 to include the dependent module(s) in the initramfs.
    return 0

}

# Install the required file(s) for the module in the initramfs.
install() {

inst_multiple -o \
        "$libdir/repart.d/*.conf" \
        "$systemdsystemunitdir"/systemd-repart.service \
        "$systemdsystemunitdir"/initrd-root-fs.target.wants/systemd-repart.service \
        systemd-repart

# Systemd-repart is capable of also formatting the created partition.
    # Support all filesystems that repart.d supports.
    inst_multiple -o \
        "mkfs.ext4" \
        "mkfs.btrfs" \
        "mkfs.xfs" \
        "mkfs.vfat" \
        "mkfs.erofs" \
        "mksquashfs"

# Install the hosts local user configurations if enabled.
    if [[ $hostonly ]]; then
        inst_multiple -H -o \
            "/etc/repart.d/*.conf" \
            "$systemdsystemconfdir"/systemd-repart.service \
            "$systemdsystemconfdir/systemd-repart.service.d/*.conf"
    fi
}

← 返回文件管理器